14
EN
■
Do not use the device for drying laundry.
■
In the event of a fi re: Do not extinguish with water! Smother the fl ames with a fi re-
proof blanket or a suitable fi re extinguisher.
WARNING – Danger of Injury
■
Keep children and animals away from the packaging material. There is a danger of
suffocation.
■
Make sure that the connecting cable is always kept out of the reach of small children
and animals. There is a danger of strangulation.
■
Lay the connecting cable in such a way that it does not present a trip hazard.
■
Do not aim the heater at animals or plants.
NOTICE – Risk of Damage to Material and Property
■
Set up the device so it is protected from the weather.
■
Store the device only in closed rooms.
■
Do not use and store the device in rooms with high humidity. Protect the device from
persistent moisture.
■
Always switch off the device fi rst before the mains plug is pulled out of the plug
socket.
■
Pull the mains plug out of the plug socket before a thunderstorm.
■
Never pull or carry the device by the mains cable. When you pull it out of the plug
socket, always pull on the mains plug and never the mains cable!
■
Lay the connecting cable in such a way that it does not become squashed or bent
and does not come into contact with hot surfaces.
■
Do not subject the device to any impacts.
■
Protect the device from fi re, other heat sources and sub-zero temperatures.
■
Use only original accessories from the manufacturer in order to guarantee that there
is no interference that may prevent the device from working and to avoid possible
damage.
■
Do not lay or place any heavy objects on the device or the connecting cable.
Assembly
PLEASE NOTE!
■
The minimum distance of the radiant heater from the ceiling must be 30 cm,
from the ground 180 cm and from the other sides 100 cm
in order to guarantee
a suffi cient distance between people, animals, plants and objects and the device
and prevent burns.
You also require a cross-head screwdriver and a spanner for the M 6 nuts.
1. Fix the bottom rod (
12
) on the base (
8
) (
Picture C
). To do this, insert the M 6 x 35 mm
screws (
4
) from above through the holes in the rod and the base and fasten them
tight on the bottom of the base with the M 6 nuts. To do this, you will also require
the small hex key and a spanner.
2. Place the cover (
11
) on the rod (
Picture C
).
3. Push
the
connecting
cable (
7
) from below through the base, the bottom rod and the
middle rod (
10
). Screw the middle rod onto the bottom rod (
Picture D
).
i
05101_Inlay_DE-EN-FR-ES-IT_A5.indb 14
05101_Inlay_DE-EN-FR-ES-IT_A5.indb 14
23.03.2021 14:29:57
23.03.2021 14:29:57
