®
Sportsman
®
S+
EN
20
Deactivating GPS
Out of the box the aircraft’s GPS feature is activated.
However, you may choose to deactivate the GPS system
to perform a control direction test indoors or to simply
enjoy the aircraft without GPS features.
IMPORTANT:
When the GPS feature is deactivated, the
aircraft’s Holding Pattern, AutoLand and Virtual fence
features will not function.
To deactivate the GPS system, ensure that your transmit-
ter is bound the the aircraft.
1. Remove the wing to have full visibility of the reciever.
2. Connect a fl ight battery and place aircraft straight and
level on it landing gear.
3. When the recievers blue and red LEDs blink rapidly
(indicating GPS initiation), hold full right aileron stick
and quickly toggle the dual rate switch rapidly 4
times.
4. Within 3 seconds the red LED goes off and the blue
LED will blink slow indicating GPS is OFF.
To reactivate the GPS feature simply disconnect and then
reconnect power from the aircraft and the GPS sysetm
will be active.
Service and Repairs
NOTICE:
After any impact or replacement always ensure
the receiver/GPS module is secure in the fuselage. If you
replace the receiver, install the new receiver in the same
location and orientation and as the original receiver or
damage may result.
Thanks to the Z-Foam
™
material in your aircraft, repairs
to the foam can be made using virtually any adhesive (hot
glue, regular CA [cyanoacrylate adhesive], epoxy, etc).
NOTICE:
Crash damage is not covered under warranty.
When parts are not repairable, see the Replacement Parts
List for ordering by item number.
Use of CA accelerant on your aircraft can damage paint.
DO NOT handle the aircraft until accelerant fully dries.
2
1
3
4
Keep immobile and out
of the wind for
5 seconds
2
1
3
GPS
GPS
