2. Once you're satisfied that the wing is centered,
attach the wing using the 6 rubber bands
provided. Stretch two of the rubber bands from
the front to the rear attach points. Stretch the
next two diagonally across the middle. Stretch the
last two rubber bands from the front to rear attach
points as you did with the first two. Once the
rubber bands are in place, confirm the wing is
securely attached.
3. Before each flight, make sure the front and
trailing edges of the wing are exactly centered
on the fuselage.
Rc
Step 2
5
Step 1
4
Mounting the Landing Gear
1. Insert the landing gear into the slot on bottom
of the fuselage.
Note: When flying without X-port
™
modules and
landing on grass, it is not necessary to have the
landing gear installed.
Attaching the Wing
1. Center the wing on the fuselage by aligning
the center dot on the wing with the fuselage
top seam and by centering the half circle on
the wing’s trailing edge over the fuselage
center.
1. Remove the transmitter back cover by pushing down
with your thumbs, as indicated.
2. Install batteries. Use fresh 1.5V "AA" and watch
the polarity.
3. Replace the cover.
4. To test, switch on the transmitter—the LED should
glow brightly.
5. Replace the batteries when you hear
the low-battery alarm (beeping sound).
Needed for Step 1
8 "AA" Batteries (included)
Transmitter
Needed for Step 2
Rubber Bands (x6)
Main Landing Gear
Wing and Landing Gear Attachment
5723_HBZ(fb cllngr. manual) 5/28/03 5:00 PM Page 4
