ENGLISH
fra
N
ç
a
IS
DEUTSCH
7
HOw TO CONTROL YOUR MOdeL
NeUTRAL
LeFT
RIgHT
If the wheels operate in the opposite direction, operate the servo reverse switch (ST in position NOR).
esp
a
Ñ
ol
❶
❷
❸
Max 1mm open!
Max 1mm open!
Carburator max open!
SeTTINg FULL THROTTLe
SeTTINg FULL BRAke
SeTTINg NeUTRAL
BATTeRY Led INdICATOR
- During normal operation, the LED should be solid green ON
- When battery voltage is dropped below 3.8V, the LED will become red color and flashing very slowly, to indicate battery is low, you should
replace new battery as soon as possible.
PROgRAMMINg THe eNd-POINTS
Steering End-points programming
1) Steering End-points programming
• To set the Right End point of Steering:
- During normal operation, hold the Steering wheel at right-most, and
then hold the BIND key over 1 sec
- LED will become solid red color, and the Right End-point will be
reset to max value
- Next, use the steering wheel to let the steering servo point at the
expected right most location. Now, pressing the BIND key to save this
Right End Point: the LED will be flashed 4 times while data is saved.
• To set the Left End point of Steering:
- Similar to above, logically hold the Steering at Left-most position
and hold the BIND key over 1 sec.
Throttle End-points programming
• To set the Forward End point:
Similarly, hold the Throttle at Forward-most position to set Forward
End Point, hold the BIND key over 1 sec to enter Forward End Point
programming...
• To set the Reverse End point:
Similarly, hold the Throttle at Reverse-most position to set Reverse
End Point, hold the BIND key over 1 sec to enter Reverse End Point
programming...
