ENGLISH
fra
N
ç
a
IS
DEUTSCH
5
esp
a
Ñ
ol
even if THiS CAr iS A reAdy To run kiT, you STill HAve SoMe liTTle THinGS To do To fAMiliArize WiTH
your ProduCT. PleASe folloW THeSe STePS.
A
Remove the 2pcs receiver box clips from the cover of the receiver box.
B
Install the battery case in the receiver box properly and connect the red plug.
You can close the receiver box cover.
INSTALL THe ReCeIVeR BATTeRY
B
A
BATTeRY INSTALLATION
Supplied with 4 x 1.5V AA Batteries,
KT2S can be operated a few hours.
Installation:
❶
Remove the battery
compartment cover as shown below.
❷
Install the batteries observing
the polarity marked on battery
compartment.
❸
Then reinstall the battery
compartment cover as the
Picture shown below.
CAUTION :
Do not dispose of batteries in fire, short their terminals,
apply heat to them or disassemble them. .
Used batteries: Please dispose of used batteries properly,
following any local regulations.
Battery distributors are required by law to take back spent
batteries; they must not be thrown away as household
waste.
You must check the signal of transmitter and receiver before
you operating it at first.
Make sure th trim is on neutral
- turn oFF the transMitter and receiVer -
A
Turn on the switch of the battery case
B
.
Press and Hold the BIND button on the receiver
Release the BIND button when the LED flashes green.
While the green LED flashes, press the BIND button to select the
frame rate.
- Faster flashes= high frame rate (7ms), for digital servo
- Slower flashes= low frame rate (15ms), for analog servo
C
Press and Hold the BIND key of the Transmitter
(1)
, and then
turn on the Transmitter
(2)
, the Transmitter will communicate with
the receiver.
BINd
B
(1)
(2)
C
A
Place model on a block to prevent wheels from touching the ground
when the receiver Led is solid on, the pairing process is done, and the receiver is paired with the transmitter.
