23
Y
Y／
2
(In case of 3-post)
5
Y
21.8
(cutting)
5
Y
21.8
(cutting)
5
21.8(cutting)
Y
φ3(on U-shape gutter)
φ3(on U-shape gutter)
φ3(on U-shape gutter)
※
When cutting the roof on length direction, move the post as the same
length as the cutting dimension of the roof. (In case of D72 and D80
the post in the center also need to be moved.)
Y
Y
Be careful of the direction of each materials.
There are right and left directions.
1. Cutting the gutter
2. Cutting the middle frame
3. Cutting the main frame
4. Cutting the panel holder
5. Cutting roof panel
6. Cutting roof panel support
2. Middle frame processing
Cut the materials as the same length as the cutting
dimension of the roof (Y).
1. Gutter processing
Cut the materials as the same length as the cutting
dimension of the roof (Y).
15
Cutting procedures of length direction
The panel span is 715mm. In case of cutting on length direction, the cutting dimension of the roof Y is the
multiples of 715mm is recommended. And cut the materials from opposite side of round gutter installation.
Cut range
Y=less than 1430mm (less than 2 panel
pitch)
※
It can’t be cut from 465mm to 535mm
for installing drain hole.
From 651 to 714mm and from 1366 to
1429mm are not available because the
side frame overlaps to the roof rafter.
