8
5
WWW.HOBBYKING.COM
Servo arm must be 90 degrees to the pushrod.
8-10mm
INSTALLING THE RUDDER SERVO
Cable ties
Cut off excess.
Cut off excess.
Hex driver
1.5mm
Hex driver
2.5mm
Steering Stick
Turn model to left or
right.
Steering Trim
Adjusts the steering in
small increments so
the model will run
straight.
Power Switch
Battery Level Indicator
Two LED display to indicate battery voltage level.
If the Red led flashes, replace batteries.
Antenna
Servo Reversing Switch
Throttle Stick
Control the speed of
the model and
movement forward
and backward.
Throttle Trim
Adjusts the throttle in
small increments so
the model will not
move at neutral.
Battery Cover
See enclosed information.
ESC SET
TRANSMITTER OVERVIEW
BOAT MAINTENANCE
ring Stick
model to left or
Antenna
Batte
Drive line
1. Loosen the motor coupler set screws for the flex cable.
2. Slide the flex cable with marine grease.
3. Lubricate the flex cable with marine grease.
4. Lubricate the drive ball bearings with a light oil for bearings.
5. Reassemble the drive and wipe away any excess grease and oil.
10mm
WATER COOLING INTAKE
Motor coupler set screw
U
se high quality marine grease to
lubricate the flex
i
cable.
Tension
Feed the
pushro
d
through
the rubber
b
ellow
s and
connect to
the serv
o.
