9.8.1. Servo Trimming
This function allows you to adjust the center position of the servos using the transmitter. It will be more convenient and more
intuitive.
Click the “Servo Trimming” button to enter the setting procedure in the “Servo” page. After entering, move the elevator stick
up or down to select one of the servos connected at [OUT1] to [OUT5] (the pass-through channels will be skipped
automatically). The current servo will indicate its selection to you by a short up and down move. By default, the servo
connected at [OUT1] is always the first one selected after you entering the procedure.
When the desired servo has been chosen, move and hold the aileron stick into one direction to change the center position
for it, when it reaches the desired position release the aileron stick and wait for about 2 seconds until the LED turns solid
violet, the current servo position will be saved as the new neutral automatically. While moving the servo, the LED will blink
blue and a rapid red blinking indicates that the servo has reached the maximum center position allowed. The new neutral
position of current servo will also be saved when you switching to the next servo.
After you have finished the setting, just flip the flight mode switch or click the Exit button to exit and back to standby state.
