
13
SySTEM SETUP anD inSTaLLaTiOn
WARNING
It is extremely important that the receiver antenna wires be mounted as described. This will ensure that your
aircraft receives control signals no matter what its posture, attitude, or heading.
l
The receiver antenna wires consists of two coaxial cables and two reception wires (the thin tip at the end of the coaxial cables).
When you mount the receiver antenna wires, do not bend the reception wires. Reception performance decreases if the reception
wires are bent.
l
The receiver antenna wires are delicate, therefore, handle with care. Do not pull on the receiver antenna wires with force. Do not
cut or extend the receiver antenna wires.
l
The coaxial cables (the thicker portion of the receiver antenna wires) can be bent into gentle curves, however, do not bend the
coaxial cables acutely, or repeatedly bend them, or the antenna cores can be damaged.
l
When installed in an electric-powered aircraft, keep the receiver antenna wires as far away from the motor, battery, and electronic
speed control (ESC) as possible.
l
When installing the receiver, the antenna reception wires (the thin tip at the end of the coaxial cables) should not come into contact
with any carbon or metal components (conductive components). Aircraft fuselages may contain conductive components. If mounting
the receiver surrounded by conductive materials (for example, a carbon fiber fuselage), mount the receiver so that the antenna
reception wires can be extended outside of the aircraft. Reception can be blocked if the antenna reception wires are shielded inside
a carbon fiber fuselage.
Tape can be used to secure the antenna reception wires to your aircraft. Alternatively, cut two
short pieces of plastic tube and slide one antenna reception wire into each piece of tube, then
tape or glue the tube to your aircraft. The tubes will protect the antenna reception wires from damage.
If mounting inside a carbon fiber
fuselage, the antenna reception wires
must be run outside of the aircraft as
described in the notation below.
MOUnTing ThE REcEivER, cOnTinUED....
Summary of Contents for Aero Sport 5
Page 1: ...1...