c
32
21
Install and glue two wing sheeting gus-
sets WGS. These will install at the wing
tip at the corners of W12 and TES and
W12 and the bottom spar flange SPF-B.
These will support the wing tip sheeting
and should be glued in flush with the bot
-
tom of W12.
c
34
Install and glue the bottom wing tip sheet-
ing, WTS-B.
c
35 Install and glue the bottom leading edge
sheeting BLE.
c
36
Plane or sand the leading edge perfectly flat in preparation for installing the leading edge. Locate
and install LE, use push pins and tape to secure it until the adhesive has set. Plane and sand the
leading edge to contour with the ribs. It is important to use the lite ply Wing Leading Edge Tem-
plate supplied to shape the leading edge. A leading edge that is misshaped can have undesirable
flying characteristics.
This concludes the assembly of the left wing panel. Return to step one of the wing assembly
instructions and repeat steps 1 through 35 for the right wing panel. Remember to reverse the pro-
cedure to install SBC onto the sheer webs. Sand all surfaces in preparation for covering. Cover
the wings with your preferred covering system.
Use Epoxy or PU glue to assemble the wing platform and the wing halves.
Flap assembly
c
1
When assembling the flaps, you will be
making a left and a right flap. It is best
to assemble both flaps at the same time
to avoid making two of the same hand.
Place the flap base (FLB) on the bench
and glue the flap hard point (FLHPB) in
the notch provided. The correct orienta-
tion is with the labeled edge toward the
leading edge.
c
2
Glue the flap leading edge (FLE) to the
flap base assembly.
c
3
Glue all flap ribs (FL-2 & FL-1) to the flap
base assembly.
ABOVE: FHP has been glued into FB, note the correct ori-
entation. The notch should be closest to the leading edge.
