Hobby Lobby International TEL1600, Manual, Page: 9 / 32

7
c
29 Apply a bead of aliphatic resin glue to the
leading edge of ribs W1 and W2 under the
sheeting and along the entire leading edge.
Use four inch pieces of masking tape at each
rib to pull the leading edge sheeting tightly
down against the ribs and the leading edge.
Turn the wing over and apply thin CA to
each rib to complete the leading edge sheet-
ing installation. Trim and sand as necessary.
The leading edge is checked with a straight edge for contour to the
ribs in preparation for installing the leading edge sheeting.
The leading edge is shaped to contour with all ribs and W1-IN in
preparation for installing the top leading edge sheeting.
The leading edge sheeting is first glued to the top spar and held
firmly in place with strips of masking tape until cured.