Install the canopy to the fuselage with screw and connector
Install the the propeller and spinner to the motor .tighten properly.
Moving the accu pack make the model balance .
cut opening In the fuselage for accu pack –the hole must be about
1mm smaller of each side ,the fuselage foam will hold the accu
pack in the right position.
The accu pack press into the hole in fuselage .
Final Check
Check the model. It must be symmetrical and not twisted.
Radio control set installation
review top and side view, showing a basic radio installation. Put accu
pack in fuselage as shown. Accu pack will be used for balancing the
P51D. Use instruction guide for speed controller for operating with electro
power set.
Centre of gravity
Support your model with your fingertips. It should balance, slightly nose
down, when your finger tips are 45-55mm behind the leading edge of the
wing. Move the battery to balance your
modell properly. Do not try to fly
an out-of balanced model, as it will crash!
Flying
Check each control surface for the correct movement and adjust
pushrods. Checking running of the motor. For taking of you need a flying
field about 100m long without trees around. Hold your model on the hand ,
put ¡±
full gas¡±
. Throw the model in the air little bit nose up .Move elevator a
little bit up and warbird will be in the air .
Fix the end of PVC without hole to the front of the canopy with glue.
