7
Glue the wire into upper side of the wing using CA glue and activator
spray .
Use the same procedure glue the wire on the bottom side of the wing .
12mm
Cut a slots in the ailerons of wing for the control horns as shown .
Glue the control horns into the ailerons using CA glue and activator
spray .
A
B
A
＝
B
90
C
＝
D
Insert wings into the fuselage as shown . check if the wings is the
centre and in the right alignment .Also check if the wing is
perpendicular to the fuselage side .
Glue the wing in place using CA glue . Apply glue at the top and
than to the bottom (as shown)
Insert the control wires into the ailerons horns and into pushrod
connector as shown .switch on the RC-system for to have the servo
in neutral .put the ailerons in neutral .Now the pushrod connectors
screws must be tightened.
Hollow out the canopy with sharp knife and make enough space for
servo arm working
44mm
