Using sharp knife cut an opening for ailerons servo .The opening
must be 1mm smaller from each side.
15mm
Into the fuselage drill the 8mm hole for aileron servo cable up to
the space for receiver.
Glue the extension of the servo arm onto the ailerons servo arm
using CA glue.
Before gluing rough the arm and extension.
Insert connectors into extension of the servo horn .
Insert the ailerons servo into the hole and put through the servo
cable into the opening for receiver .glue the servo using fusion
glue.
Using sharp knife cut an opening for ailerons servo horn.
Switch on the RC-set for to have the servo in neutral .install the
servo horn on the servo.
Insert the receiver into place .the fuselage foam will hold it in place
.plug the elevator ,rudder and aileron servos and ESC conectors
into receiver.
Put the servo cables into the opening around the receiver.
5
