CONTROL ROD ADJUSTMENT RADIO INSTALLATION
1. Be sure that your radio system is fully charged and the servos are
plugged into the receiver. Turn on the transmitter then receiver. Set
the trim levers to the neutral position. Turn the receiver then the
transmitter back off.
4. If using the Snap 'R' Keeper mark on the push rods where the hole
in the servo arm is.
2. Adjust the servo arms so that they are positioned as shown above.
The screw holding the arm on may need to be removed so that the
arm can be removed and adjusted.
5. Make a 90' bend at the mark on the push rods. Cut the excess wire
as shown, and install the Snap "R" Keepers to the rod and servo arms
following the manufacturer's instructions. If using E-Z connectors
install them on the servo arms and attach the rods following the
manufacturer's instructions.
3. Set the rudder and elevator so that they are in the neutral position as
shown.
6. With the transmitter and receiver on, set the throttle to full speed on
the transmitter. Set the throttle arm on the carburetor to full power.
Install the push rod as instructed in the previous step. Next, install
in order the spinner back plate, prop, prop washer, prop nut, and the
spinner. Use the two 2 x 1 2 self-tapping screws to secure the
- 1 5 - spinner.
