11
the transmitter is in low rates, the mode indicator on the LCD screen will show
a half oval and emit a single low pitch beep. For high rates, the indicator will be
a complete oval and the transmitter will emit a single high pitch beep.
®
CAMERA OPERATION
CAMERA OPERATION
Installing the Memory Card
Remove the memory card from the
protective case. Flip the model over and
push the card into the slot on the side
of the camera module. When the card is
correctly installed, it will click. To remove
the card, simply press on the card again
and the inner spring system will help
eject the card. The card should only be
installed and removed when the battery
is not connected to the helicopter.
NOTE:
The card must be in place to capture
video or pictures. The camera has no internal memory.
The camera will be in VIDEO mode when it is first powered up. Press the VIDEO
button to start recording a video. You will see the LED on the side of the camera
flash slowly while the video is being captured. To stop recording and store the
video, press the VIDEO button again. The LED will stop flashing to indicate that
the camera is ready for use. If the memory card is ejected or the battery unplugged
while the camera is recording, the video will NOT be saved on the card.
Before the camera can take a photo, it
must be in the PICTURE mode. Press
the PICTURE button one time, to change
the mode if it is in VIDEO mode. The
LED on the camera will remain steady
while the camera mode is changed. After
the camera is in PICTURE mode, press
the PICTURE button to take a photo.
You will notice that the LED will flash
rapidly as the picture is recorded and
stored on the memory card. When the
LED stops flashing, the camera is ready to take another photo. If the PICTURE
button is pressed while the LED is flashing, the camera will not capture another
photo. The VIDEO button must be pressed once to change modes before the
camera will capture a video.
