HMS LOOP15, Manual

Page: 18 / 52

Shutdown
You can turn off the power to shut down the treadmill any time.
Belt Middle Placement:
•
Put the motorized treadmill on the level ground.
•
Let the treadmill run at the speed of 6km/h, observe the running belt deviating
condition.
•
If the running belt deviate to the right, pull off the safety key and unplug the power,
turn the right side adjusting bolt clockwise by 1/4 circle, plug the power ,safety key,
make the treadmill run, watch the running belt deviating condition.
•
Repeat the above steps, until the running belt is in the middle. Picture A
•
If the running belt deviate to the left, pull off the safety key, unplug the power, turn the
left adjusting bolt clockwise by 1/4 circle, plug the power, safety key, make the
treadmill run, watch the deviating condition of the
running belt.
•
Repeat the above steps, until the running belt goes to the middle. Picture B.
•
After the above adjustment or a period of time’s use, running belt would become
loosen, need djustment.
Pull off the safety key, power switch, and turn the left and right adjusting bolt clockwise
by 1/4 circle, plug power, safety key, make the treadmill run, then stand on the treadmill
to confirm the tightness.
•
Repeat above steps, until the running belt is moderate in tightness.
picture C.
A .If the running belt doesn’t stop when you press it, the running belt and motor belt is not
flabby nor tight. They are just right;
B .If the running belt stops when you press it, but the motor belt and the front roller don’t
stop, the running belt is a little loose, then you need to adjust the running belt for the safe
use(to adjust running belt loose and tightness see the maintenance guideline in the before
page);
C . If the running belt and motor belt stop when press the running belt, the motor still
run, the motor belt is flabby, you need to adjust it for the safe use.