27
BE2235
Malfunction
Error
Specification
Treatment
Er1
Connect error between panel and controller
Check that the lines between panel and controller are
connected or not.
Er2
Error on motor/MOS crash
Check that the line to motor is connected or not.
Er3
Error on speed sensor line/Un-work of walking belt.
Check that the walking belt is locked by remoras.
Check that the speed sensor line is connected or not.
Check the placement of sensor or the photo disk is correct
or not.
Er4
Binding of RELAY
Replace the device
Er5
Over the current
Check the loading.
Er9
Safety key not plug in
Check Safety Key
Monitoring Your Heart Rate
The treadmill is fitted with 2 hand pulse sensors. To obtain a pulse
reading you must have both your left and right hands on the sensors at
the same time. Do not grip the hand sensors too tight and allow the
computer a few seconds to display the reading.
NOTE: Some people may not be able to obtain an accurate hand pulse
reading due to variations in circulation.
Adjusting Incline
To adjust the incline level, pull out the fix pin and raise or lower main
frame. Then reinsert fix pin.
