HMS Networks Intesis INKNXDAL0640200, User Manual

Page: 18 / 41

Intesis
TM
KNX
– DALI
User Manual r1.0 EN
© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
URL http
s
://www.intesis.com
18 / 41
3.3.3 Broadcast signals
Broadcast signals allow to control all ballasts in the same line from an individual signal.
Supported signals vary according to device type, configured through Intesis MAPS.
Following abbreviations are done in the table:
•
FL: Fluorescent light (device type 0)
•
EML: Emergency light (device type 1)
•
LED: LED module (device type 6)
TOPIC
Ballast /
Device Type
NAME
LEN
DATAPOINT TYPE FLAGS
FUNCTION
FL
EM
L
L
E
D
DPT_NAME DPT_ID U T Ri W R
COMM
ERR
x x x Arc Power Level
1 bit DPT_Alarm 1.005 U Ri W
R
0 to 100 %
x x x Arc Power Off / On
1 bit DPT_Switch 1.001 U Ri W
R
0-Off; 1-100 %
x x x Step Down / Up
1 bit DPT_Step 1.007 U Ri W
R
0-Step Down
1-Step Up
x x x Recall Min Level
1 bit DPT_Start 1.010 U Ri W
R
1-Recall Min Level
x x x Recall Max Level
1 bit DPT_Start 1.010 U Ri W
R
1-Recall Max Level
x x x Go to Scene
1 byte Unsigned Value 5.x U Ri W
R
0 to 15
x x x Store Current Level as Scene
1 byte Unsigned Value 5.x U Ri W
R
0 to 15
x x x Clear/Remove Scene
1 byte Unsigned Value 5.x U Ri W
R
0 to 15
x x x Set Fade Time
1 byte Unsigned Value 5.x U Ri W
R
0 to 15
x x x Set Fade Rate
1 byte Unsigned Value 5.x U Ri W
R
1 to 15
FLAGS:
If marked with a black " x " will be enabled by default and couldn't be disabled.
If marked with red " x " , column will be disabled by default but could be enabled by user.
If marked with blue " x " , column will be enabled by default but could be disabled by user.