• English
- 33 -
Rigging Manual 1.0
COSMO Line Array – Instructions for use
5
Attach the rigging frame's fl ap using the hole labeled link in
this M/H unit's rear angle plate. Now insert the loose end of the
tensioning strap with the crane hook into the rigging frame's
lower shackle.
Link
0°
2°
4°
6°
8°
10°
1°
3°
5°
7°
9°
/
6
Remove the quick-release pins of the lowest M/H unit on the
C-WB and lift the array until the entire load is suspended from
the lifting accessories and link pins.
7
Now set all mid/high units' angle pins to the desired position on
the angle plate (see the pictured example for a 4° angle).
Link
0°
2°
4°
6°
8°
10°
1°
3°
5°
7°
9°
/
Heads up: Remove and replace angle pins only when
the array is suspended and there is no load on them;
otherwise, you run the risk of pinch/crush injuries.
8
Raise the array just high enough for the next C-WB to slide in
below it.
9
Remove the C-WB's cover and insert the quick-release pins to
connect the front sides of neighboring M/H units (see step
4
above).
10
Attach the fl ap of the lowest suspended M/H unit to the link
hole of the top M/H unit on the C-WB (see step
5
above).
Repeat steps
6
through
10
until all components required for the
speaker array are connected.
6 Cur
ving in C
ompressed Mode
