ENGLISH
55
Install / Replace Batteries
Use two alkaline dry batteries (R03/LR03X2). Do not use
rechargeable batteries.
(1) Remove the battery cover by pulling it according to
the arrow direction.
(2) Insert new batteries making sure that the (+) and (-) of
battery are installed correctly.
(3) Reattach the cover by sliding it back into position.
Automatic Operation
When the Air Conditioner is ready for use, switch on
the power and the OPERATION indicator lamp on
the display panel of the indoor unit starts flashing.
1-
Use the Mode select button to select AUTO.
2-
Push the or button to set the
desired room temperature. The most comfortable
temperature settings are between 21 C to 28 C.
3-
Push the On/off button to start the air conditioner.
The OPERATION lamp on the display panel of the indoor
unit lights. The operating mode is AUTO. The FAN SPEED
is automatically controlled.
4-
Push the On/off button again to stop the unit operation.
COOL , HEAT, and FAN ONLY Operation
1-
If the AUTO mode is not comfortable , you may
manually override the settings by using COOL, DRY,
HEAT( HEAT PUMP units only), or FAN ONLY modes.
2-
Push the or button to set the desired room
temperature. When in COOLING mode, the most
comfortable settings are 21 C or above. When in
HEATING mode, the most comfortable settings are
28 C or below.
3-
Push the Fan button to select the FAN mode of AUTO,
HIGH, MED or LOW.
4-
Push the On/off button. The operation lamp lights and
the air conditioner starts to operate per your settings.
Push the On/off button again to stop this unit operation.
OPERATING THE REMOTE CONTROLLER
•
When replacing batteries, do not use old batteries or a different
type battery. This may cause the remote controller to
malfunction.
•
If you do not use the remote controller for several weeks
remove the batteries. Otherwise battery leakage may damage
the remote controller.
•
The average battery life under normal use is about 6 months.
•
Replace the batteries when there is no answering beep from
the indoor unit or if the Transmission Indicator light fails to appear.
NOTE
•
In the AUTO mode, the air conditioner can logically choose
the mode of COOL, FAN, HEAT and DRY by sensing the differen-
ce between the actual ambient room temperature and the set
temperature on the remote controller.
•
If the AUTO mode is not comfortable for you , the desired
mode can be selected manually.
NOTE
•
The FAN ONLY mode cannot be used to control the temperature.
While in this mode, only steps 1 3 and 4 may be performed.
NOTE
06ManualMandoDEng 2/1/07 13:34 Página 55
Summary of Contents for ASE 129U11iM
Page 2: ......
