addresses on a network. DHCP is enabled by default. Although a DHCP server is mostly
used to set an IP address dynamically, it is also possible to use it to set a static, known IP
address for a particular MAC address.
• Use the following IP address - To use a static IP address for the Network Transmitter,
check the radio button and then make the following settings:
-. IP address - Specify a unique IP address for your Network Transmitter.
-. Subnet mask - Specify the mask for the subnet the Network Transmitter is located on.
-. Default router - Specify the IP address of the default router (gateway) used for
connecting devices attached to different networks and network segments.
Note:
1. DHCP should only be enabled if using dynamic IP address notification (see below), or if
your DHCP server can update a DNS server, which then allows you to access the
Network Transmitter by name (host name). If DHCP is enabled and you cannot access
the unit, you may have to reset it to the factory default settings and then perform the
installation again.
2. The ARP/Ping service is automatically disabled two minutes after the unit is started, or
as soon as an IP address is set.
3. Pinging the unit is still possible when this service is disabled.
3.5.1.3 Video & Image
• Video Setting
16
