3
STEP
Connect the EBBU to the device
Connect the EBBU to the device
Safety warnings
Check LED status
5
STEP
After powering up the device, the Status LED will be in one of the
following states.
Connect power adapter to EBBU
4
STEP
Plug the power adapter to a wall jack and connect it to the EBBU’s
Power port.
IEC 62368-1
All equipment is to be designed to allow installation according to the National Electrical Code (NEC), ANSI/NFPA 70, the Canadian Electrical Code (CEC),
Part I, CAN/CSA C22.1, and when applicable, the National Electrical Safety Code, IEEE C2. Also, for such equipment marked or otherwise identified, installation is allowed per the Standard for the
Protection of Information Technology Equipment, ANSI/NFPA 75. RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE TO DISPOSE OF USED BATTERIES ACCORDING TO INSTRUCTED
SAFETY WARNING:
Risk of electrical shock if the device is exposed to water or moisture. This unit is designed for home and office environments, do not use the device outdoors. Keep the device in an environment between 0°C-25°C (32°F-77°F). To avoid overheating,
do NOT place any object on top of the device or restrict the flow of air around the device. The manufacturer assumes no liability for damage caused by any improper use of the device. Only use the cables offered with the device.
DISCLAIMER:
The manufacturer assumes no liability with respect to the contents of the document. The manufacturer also reserves the right to revise this document or update the content thereof without any obligation to notify any person of such revisions or
amendments. Specifications subject to change without notice.
LIMITED WARRANTY:
Each EBBU and its accessories have a rated lifespan of over 3 years. The EBBU support a standby-time of at least 24 hours with 2 fully-charged batteries and 12 hours with 1 fully-charged battery during a power-outage (includes all voice ports, but
no calls during this time interval). The EBBU’s battery capacity can vary depending on storage time and temperature.
Battery Replacement:
To reduce the risk of fire or electric shock, install batteries in a temperature and humidity-controlled indoor area, free from conductive contaminants. When replacing batteries, the replacement should use the same battery pack—Getac Technology
Corp. type C4589 or contract manufacturers. Deliver spent batteries to a recycling facility in accordance with local regulations. Don’t dispose of batteries in a fire as batteries may explode if improperly disposed.
FCC
This equipment is in accordance with the procedures given in ANSI C63.4-2014 and the energy emitted by this equipment was passes FCC Part 15 Subpart B and ICES-003, Issue 6 Class B. Conducted and
radiated emissions comply with Class B limits.
Off:
Red- Steady:
Red- Blinking:
Green- Steady:
Green- Blinking:
Orange- Steady:
Flicker between orange and red:
Boot-up failed
Any battery life is less than 50%
No AC power on the power outlet
Normal operation with 100% charge
Normal operation with less than 100% charge
Initialization
No battery loaded
Reset
1
Tel
2
USB
Ethernet
Cable
Power
Battery
1
2
3
4
Reset
1
Tel
2
USB
Ethernet
Cable
Power
Battery
1
2
3
4
Install batteries into the EBBU
Screw in the 2 screws.
BATTER
Y
MODEM
BATTER
Y
MODEM
5
Modem marking
Power plug to EBBU
Battery marking
Battery plug to cable modem
Battery plug to EBBU
Power plug to cable modem
Lock 2 screws and make sure the
door is fixed properly on the EBBU.
6
