11
ALWAYS THE BEST SOLUTION
HITROL CO., LTD
1
2
3
4
3. INSTALLATION OF MEASURING TAPE (WEIGHT SIDE)
4. REFERENCE FOR THE BOTTOM ANCHOR INSTALLATION
1. Bottom Anchor is a user scope so it should be prepared by user.
2. It is recommended to install the bottom anchor before installation of tank level
gauge in order to prevent a change of it's location.
3. It is recommended to put the bottom anchor to the bottom of our guide pipe
first and adjust the upper position. After fixing of the upper position, fix the
bottom anchor to the tank bottom.
1. Connect the folded measuring tape to the weight as above. The length of bolt
should not be over 10mm because long bolt can cause a malfunction of the
gauge.
2. Put the weight connected with the measuring tape to inside the tank through
the seal pipe.
3. After put of weight, check whether the measuring tape gets out of the roller
or not. If not, complete the installation of measuring tape after assembly of
elbow cover.
3-1. Folding of Measuring Tape
Fold the measuring tape on Elbow-A as below order.
•
* PRECAUTION :
• Temporarily fixing the measuring tape on upper elbow
suitable for each site condition.
• Take care not to bend or give damages to the measuring
tape when folding of it.
3-2. Connection of the measuring tape to the weight
Folding
Folding
1
2
3
4
