These warnings and safety notes are of the utmost importance. You must fol-
low these instructions for maximum safety. Failure to do so can damage the
charger and the battery; and in the worst cases, may cause a fi re.
NEVER LEAVE THE CHARGER UNATTENDED WHEN IT IS CONNECTED
TO ITS POWER SOURCE. IF ANY MALFUNCTION IS FOUND, TERMINATE
THE PROCESS AT ONCE AND REFER TO THE OPERATION MANUAL.
A
The allowable DC input voltage is 11-18V DC.
A
The allowable AC input voltage is 100-240V AC.
A
Keep the charger away from dust, damp, rain, heat, direct sunlight and
excessive vibration.
A
If the charger is dropped or suff ers any type of impact, it should be inspect-
ed by an authorized service station before using it again.
A
This charger and the battery should be put on a heat-resistant, non-fl am-
mable and non-conductive surface.
A
Never place a charger on a car seat, carpet or similar surface. Keep all fl am-
mable volatile materials away from the operating area.
A
Make sure you know the specifi cations of the battery to be charged or dis-
charged to ensure it meets the requirements of this charger. If the program
is set up incorrectly, the battery and charger can be damaged.
A
Fire or explosion can occur due to overcharging.
A
To avoid a short circuit between the charge lead, always connect the
charge cable to the charger fi rst, then connect the battery. Reverse the
sequence when disconnecting.
Warning: Be sure to read this section for your own safety.
Caution: Be sure to read this section to prevent accidents
and damage to your charger.
Tip: This section will help you maximize the performance of
your charger.
Note: This section will provide more detailed explanations.
Warnings and Safety Notes
Caution
Tip
Warning
Warning
Note
Summary of Contents for X1 AC Plus
Page 1: ...INSTRUCTION MANUAL...
