3. Transmitter Battery installation
- Press down on the battery cover and slide in the direction illustrated.
- Remove the cover and install the batteries as shown.
- Remember to be careful and pay close attention to the polarity of each cell you
you could damage the transmitter.
- Replace the cover; making sure it is closed securely.
4. Recharging Batteries
Alkaline or
rechargable "AA"size
Battery Cover
Battery Case
Individual cell Battery Installation
- Connect the optional Hitec CG-25 overnight wall charger (sold separately) to the transmitter
charging jack located under the transmitter power switch to charge optional re-chargeable batteries.
- Note: If the charger is correctly hooked up to the transmitter, the red light on the
charger will be lit while charging. If it is not, check the connection or the battery.
- The CG-25 can also charge four (4) cell receiver batteries up to 1000 mAh through the
other output pigtail of the charger. Simply plug the connector into the receiver battery pack or
the charge port of the on/off switch if applicable.
- Note: If the charger is correctly hooked up to the receiver battery, the green light on the
charger will be lit while charging. If it is not, check the connection or the battery.
- A full charge on the supplied transmitter Nicad battery pack will take 12-16 hours.
- Warning: Do not attempt to charge alkaline batteries; they may explode.
Nicad Battery
Battery Holder
Battery Cover
Nicad Battery Installation
