4
Warning and Safety Notes
Hitec RCD will not be held responsible for any damages or injuries that may occur by persons who fail to follow
these warnings or who fail to properly follow the instructions in this manual.
These warnings and safety notes are of the utmost importance. You must follow these instructions for
maximum safety. Failure to do so can damage the charger and the battery and in the worst cases, may
cause a fi re.
NEVER LEAVE THE CHARGER UNATTENDED WHILE IT IS CONNECTED TO ITS POWER
SOURCE. IF ANY MALFUNCTION IS FOUND, TERMINATE THE PROCESS AT ONCE AND
REFER TO THE OPERATION MANUAL.
A
The allowable AC input voltage is 100-240V AC.
A
Keep the charger away from dust, damp, rain, heat, direct sunlight and excessive
vibration.
A
If the charger is dropped or suff ers any type of impact, it should be inspected by an
authorized service station before using it again.
A
This charger and the battery should be put on a heat-resistant, non-fl ammable and non-
conductive surface.
A
Never place a charger on a car seat, carpet or similar surface. Keep all fl ammable, volatile
materials away from the operating area.
A
Make sure you know the specifi cations of the battery to be charged or discharged to
ensure it meets the requirements of this charger. If the program is set up incorrectly, the
battery and charger can be damaged.
A
Fire or explosion can occur due to overcharging.
Warning: Be sure to read this section for your own safety.
Caution: Be sure to read this section to prevent accidents
and damage to your charger.
Tip: This section will help you maximize the performance
of your charger.
Note: This section will provide more detailed explanations.
Caution
Tip
Warning
Warning
Note
