English
43
(1) Tightening mode selector switch
By using the Tightening mode selector switch, the tightening torque can be adjusted
according to the type of work.
The Tightening mode switches between 4 di
ff
erent modes each time the Tightening mode
selector switch is pressed.
NOTE
○
The appropriate mode di
ff
ers depending on the bolt and the material being screwed.
Tighten in a few test bolts and adjust the mode setting accordingly.
○
The tightening mode selector switch can only be set after the battery has been installed in
the wrench and the trigger switch has been pulled once.
Examples of tightening mode selector function settings
Low 1 mode
Low 2 mode
Medium mode
High mode
Rotation speed
0 – 600 /min
0 – 900 /min
0 – 1200 /min
0 – 1500 /min
Use
For work that requires
fi
ne
adjustments such as when
tightening small diameter bolts.
For work that
requires the
power to be
suppressed
during tightening.
For work that
requires power
and speed during
tightening.
OPERATIONAL CAUTIONS
1. Resting the unit after continuous work
The power tool is equipped with a temperature protection circuit to protect the motor.
Continuous work may cause the temperature of the unit to rise, activating the temperature
protection circuit and automatically stopping operation. If this happens, allow the power tool
to cool before resuming use.
The motor may stop in the event the tool is overloaded. In this should occur, release the
tool’s switch and eliminate the cause of the overload.
After use for continuous work, rest the unit for 15 minutes or so when replacing the battery.
The temperature of the motor, switch, etc., will rise if the work is started again immediately
after battery replacement, eventually resulting in burnout.
NOTE
Do not touch the hammer case as it gets very hot during continuous work.
000Book̲WR36DA̲ChS.indb 43
000Book̲WR36DA̲ChS.indb 43
2017/12/28 11:03:19
2017/12/28 11:03:19
