English
39
(2) Insert the pin into the socket. (
Fig. 7
)
(3) While making sure that the pin doesn’t fall, attach the O-ring to the groove on the socket.
(
Fig. 8, 9
)
Fig. 9
Groove
Anvil
Hexagonal
socket
Hole
Hole of anvil
Friction ring
Fig. 8
CAUTION
○
Please use the designated attachments which are listed in the operations manual
and Hitachi’s catalog. Accidents or injuries could result from not doing so.
○
Make sure to
fi
rmly install the socket in the anvil. If the socket is not
fi
rmly
installed it might come out and cause injuries.
○
When sliding the O-ring out of the groove of the socket, be careful not to drop and
lose the pin.
○
It is possible to temporarily hold the socket in place with the friction ring, but be
sure to insert the pin and attach the O-ring before use.
If the power tool is used while the socket is temporarily held in place, the socket
may fall o
ff
and cause an injury.
HOW TO USE
1. Check the rotational direction
The bit rotates clockwise (viewed from the rear
side) by pushing the R-side of the pushing button.
The L-side of the pushing button is pushed to turn
the bit counterclockwise. (See
Fig. 10
). (The
and marks are engraved on the body.)
Fig. 7
Pin
Fig. 10
Trigger switch
Pushing button
Push
Push
marks
marks
000Book̲WR36DA̲ChS.indb 39
000Book̲WR36DA̲ChS.indb 39
2017/12/28 11:03:19
2017/12/28 11:03:19
