--- 17 ---
(b) Mounting the diode switch
The Diode Switch
[48]
is equipped with a high-speed/low-speed switch and a diode. Mount the Diode
Switch
[48]
to the specified position of the Housing Ass'y
[58]
as shown in Fig. 12. At this time, position the
high-speed/low-speed switch in the same direction of "H" indicated on the Housing Ass'y
[58]
.
Fig. 13
[21]
[23]
[25]
[22]
Diode
Housing
High-speed/low-
speed switch
Fig. 12
(2) Reassembly of the hammer case assembly
Reassembly of the hammer
(a) Put the twenty-nine Steel Balls D3.97
[9]
in between the Hammer
[8]
and Washer (B)
[10]
.
(b) Mount the Spring
[11]
and Washer (A)
[12]
to the Hammer
[8]
then insert the Spindle
[16]
into it. Push the
click of the Hammer
[8]
with a hand press and keep it at the position where the Spring
[11]
is compressed
fully. At this time, push the Hammer
[8]
so that the Spindle
[16]
cam top is aligned with the steel ball guide
at the Hammer
[8]
.
(c) Put the two Steel Balls D6.35
[7]
in the steel ball guide. Check that these Steel Balls D6.35
[7]
are in the
cam groove. Then release the hand press.
(3) Mounting direction of the packing washer
Insert the Packing Washer
[23]
into the Inner Cover
[21]
in the proper direction together with the Felt Packing
[22]
when mounting the Armature
[25]
to the Inner Cover
[21]
.
