--- 14 ---
(3) Removal of the Armature
[25]
Remove the Tapping Screw (W/Flange) D4 x 20 (Black)
[47]
from the Tail Cover
[46]
to remove the Tail Cover
[46]
. Remove the Brush Cap
[55]
and the Carbon Brushes
[56]
. Then the Armature
[25]
can be removed
together with the Inner Cover
[21]
from the Housing Ass'y
[58]
. At this time, be careful not to lose the Rubber
Washer
[44]
mounted between Bearing Bushing (B)
[45]
(press-fitted into the Housing Ass'y
[58]
) and the ball
bearing (at the commutator side of the Armature
[25]
). Be careful not to lose the Felt Packing
[22]
and the
Packing Washer
[23]
when removing the Armature
[25]
from the Inner Cover
[21]
.
(4) Removal of the Switch
[36]
and the Cord
[52]
Remove the Tapping Screw (W/Flange) D4 x 35 (Black)
[33]
from the Handle Cover
[34]
to remove the Handle
Cover
[34]
and Pushing Button (A)
[35]
. Remove the internal wires of the Choke Coil (White)
[30]
or the
Internal Wire (White)
[29]
, Choke Coil (Black)
[32]
or the Internal Wire (Black)
[31]
, Noise Suppressor Ass'y
[38]
, Diode Switch
[48]
and Stator
[28]
from the Switch
[36]
by inserting the pin of the special jig (Model J-86)
into each mounting hole of the internal wires and warping the leaf spring of the Switch
[36]
until each internal
wire is removed. Loosen the screw mounted to the Switch
[36]
with a small flat-blade screwdriver and remove
the internal wire of the Cord
[52]
. Then the Switch
[36]
can be removed. Remove the two Tapping Screws
(W/Flange) D4 x 16
[49]
, Cord Clip
[50]
and Cord Armor
[51]
. Then the Cord
[52]
can be removed.
Fig. 5
Fig. 6
[21]
[23]
[24]
[25]
[58]
[47]
[22]
[7]
[9]
[10]
[12]
[16]
[8]
[45]
[44]
[46]
[55]
[56]
[17]
[15]
[11]
