7
English
The tightening depth is adjusted by rotating the knob
and setting the stopper to the numerals (screw length)
indicated on the slider case.
Select a top adjuster to match screw length to be used
and attach it to the top edge. (Refer to
Fig. 9
)
Store the top adjuster in the storage room on the side
face of the slider case when it is not used.
The top adjuster is stored easily when the button
shown in
Fig. 8
is pressed.
(1) In case that you use a screw which has a length
of 25-32 mm (L), please use the top adjuster No.
1 (small).
(2) In case that you use a screw which has a length
of 35-41 mm (L), please use the top adjuster No.
2 (large).
[Fine adjustment of tightening depth]
The tightening depth adjustments (1) to (2) men-
tioned above are just preliminary.
Perform fine adjustment after trial driving.
Rotate the knob in
direction when the screw
head is too high.
Rotate the knob in
direction when the screw
head is too low.
(Refer to
Fig. 11
)
COLLATED SCREW STRIPS INSTALLATION
AND REMOVAL
1. Installation
(1) Insert the tape tip of collated screw strips into the
belt guide groove (A section).
(2) Next, insert the tape tip into the slider groove (B
section) and feed to push in the
\
direction.
(
Fig. 12
,
Fig. 13
and
Fig. 15
)
(3) Set the collated tape so that the first screw is lined
up with the slider screw mark. (
Fig. 14
and
Fig. 15
).
Top adjuster storage (rear side)
Button
Fig. 8
Top adjuster
No. 1 (small)
Stopper
Knob
Raise
Lower
Match the
stopper to
the screw
length
(25–32).
Fig. 9
Top adjuster
No. 2 (large)
Stopper
Knob
Match the
stopper to the
screw length
(35–41).
Fig. 10
Correct
(Flush)
Too high
Too low
Fig. 11
Slider
B section
A section
Belt guide
Collated screw
strips
(View from under)
Fig. 13
Fig. 12
Set one screw
forward.
(View from front)
Fig. 14
Slider
Screw
in position
01Eng_WF4DY_WE
12/24/08, 18:34
7
