4.3.1
4.3.1
4 - 3
4 - 3
(6)
(6) Set the
Set the parameters
parameters on
on the Re
the Report tab
port tab page
page as sh
as shown
own in
in
Table 4-4.
Table 4-4.
Table
Table 4-4
4-4 Report
Report Tab
Tab
Parameter
Setting
Parameter
Setting
Include
Include data
data
On
On
Include
Include method
method
On
On
Include
Include graph
graph
On
On
Include
Include peak
peak table
table
On
On
Include
Include data
data listing
listing
Off
Off
(7)
(7) Make
Make sure th
sure that there
at there is noth
is nothing a
ing at the
t the sample
sample side
side and
and
reference side of the cell holder, and securely close the
reference side of the cell holder, and securely close the
sample compartment lid.
sample compartment lid.
(8)
(8) Click
Click the
the Measure
Measure button
button or
or select
select the
the measuremen
measurementt
command from the
command from the Spectrophotom
Spectrophotometer menu.
eter menu.
(9)
(9) After
After completion
completion of
of measurement,
measurement, a
a spectrum
spectrum is
is displayed.
displayed.
Check
Check the peak
the peak value
value in the
in the peak ta
peak table.
ble. If the
If the peak val
peak value
ue
is in a range of 655.8 to
is in a range of 655.8 to 656.4 nm, the wavelength accuracy
656.4 nm, the wavelength accuracy
is norm
is normal.
al. If the
If the peak va
peak value is
lue is out of
out of the ran
the range, proce
ge, proceed to
ed to
the next step.
the next step.
(10)
(10) Select the Calib
Select the Calibrate Waveleng
rate Wavelength command from the
th command from the
Spectrophotom
Spectrophotometer
eter menu.
menu.
(11)
(11) After execution of w
After execution of wavelength cal
avelength calibration, retry
ibration, retry
measuremen
measurement.
t. If the
If the peak va
peak value is
lue is out of
out of the norm
the normal ran
al range,
ge,
then contact Hitachi service office.
then contact Hitachi service office.
(12)
(12) The analytical p
The analytical parameters can be s
arameters can be stored as an analys
tored as an analysis
is
method
method file.
file. When
When they a
they are stor
re stored, you
ed, you can p
can proceed
roceed to
to
measuremen
measurement just
t just by calling out the
by calling out the file.
file.
