Hitachi TransPortal, Installation, Operation, Troubleshooting

Page: 27 / 54

TransPortalTM Interlock Monitor
Copyright 2019 SM-1H1.0002 Rev. 2, March 2019 4-5
NOTE
The data shown in these web page views are only
representative of the configuration data required for a
specific interlocking. Each TIM must be configured with
interlocking-specific data for that location.
Each TIM must also be configured with specific network-
and SNMP-host interface parameters for that location.
• Enable ETH0? (ETH1?) Select “Yes” and configure each port as described
below:
Use DHCP?
– Select 'No" for this TIM application and enter the following:
IP Address – Enter the numeric address for the TIM. Each field must be a
whole number between 1 and 255.
Subnet Mask – Enter the subnet mask for this network. Each field must be a
whole number between 1 and 255.
Default Gateway – Enter the numeric address of the default gateway (if
used) for this network. Each field must be a whole number between 1 and
255.
Preferred DNS Server – Enter the numeric address of the preferred DNS
server (if used) for this network. Each field should be a whole number
between 1 and 255. If no preferred DNS server is used, each field should be
zero (0) or blank.
Alternate DNS Server – Enter the numeric address of the alternate DNS
server (if used) for this network. Each field should be a whole number
between 1 and 255. If no alternate DNS server is used, each field should be
zero (0) or blank.
• Run DHCP Server: – Select “No” for this TIM application.