34
How to Install the Washing Machine
Connecting the power
n
Connect the washing machine correctly to a grounded AC power supply.
n
The voltage of the power supply must match the voltage rating of the washing machine.
n
Do not use extension cords or overload the power outlet by using power strips.
Checking levelness
1. Check the center of tub
n
Set the Washing Machine at the operating area.
n
After set the Washing Machine, to check the center of tub.
n
In the case of center of tub diff erence between Left and Right too large,
re-adjust the leg of Washing Machine.
Note :
If the tub is not center, it may cause of the Washing Machine vibration or abnormal operation.
Adjustable leg
Foot
Caps
Lock nut
Lock
nut
Loosen lock nut
Adjust leg height
Tighten lock nut
Adjustable leg
Raise this leg
Lower this leg
n
Rotate the lock nut in the direction of
the arrow to loosen it and then rotate
the adjustable leg to stabilize the
Washing Machine.
n
When the adjustment is fi nished,
rotate the lock nut in the direction of
the arrow to tighten it.
2. Check the horizontal level
Following the fi gure, attach the weight at the
end of thread and drop down, can check by simplicity.
If show the same gap between A and
that is the horizontal level ± 5 mm
* Because the misalingment of Tub may due to setting
environment, it is important to adjust the center of Tub.
Checking after installation
If any of the following problems or other abnormalities occur, immediately unplug the power plug and
contact your local service center.
n
The washing machine does not operate when the power is turned on.
n
The power cord is damaged.
n
There are abnormal vibrations or sounds during operation.
n
There is a smell of burning.
Check the diff erence
between left and right
$
$
Thread
(Front or side)
Weight
Summary of Contents for SF-150ZCV
Page 36: ...3WPL124431 ...
