TC-12001
2-13
IN-THE-CEILING (DUCT)
P5414985
7
2.2
Necessary Tools and Instrument List for Installation
NOTE
About vacuum pump, gas hose, charging cylinder, gauge manifold, please use suitable
equipments for R410A respectively. Do not mix other refrigerant.
4. Indoor Unit Installation
4.1
Factory-Supplied Accessories
Check to ensure that the following accessories are
packed with the indoor unit.
NOTE
3.
Transportation and Handling
3.1
Transportation
Transport the product as close to the installation
location as practical before unpacking.
3.2 Handling of Indoor Unit
If any of these accessories are not packed with the
unit, please contact your contractor.
Do not put any foreign material into the indoor
unit and check to ensure that none exists in the
indoor unit before the installation and test run.
2WKHUZLVHD¿UHRUIDLOXUHHWFPD\RFFXU
Be careful not to damage on insulation
materials of unit’s surface when lifting.
Do not put any material on the product.
It is recommended that indoor units be installed
KLJKHUWKDQPHWHUVIURPWKHÀRRUOHYHO
O
Check to ensure that the ceiling slab is strong
enough. If not strong enough, the indoor unit
may fall down on you.
O
Do not install the indoor unit outdoors.
If installed outdoors, an electric hazard or
electric leakage will occur.
'RQRWLQVWDOOWKHLQGRRUXQLWLQDÀDPPDEOH
HQYLURQPHQWWRDYRLG¿UHRUDQH[SORVLRQ
No.
Tool
No.
Tool
No.
Tool
1
Handsaw
8
Plier
16
Cutter for Wires
2
Phillips Screwdriver
9
Pipe Cutter
17
Gas Leak Detector
3
Vacuum Pump
10
Brazing Kit
18
Leveller
4
Refrigerant Gas Hose
11
Hexagon Wrench
19
Clamper for Solderless Terminals
5
Megohmmeter
12
Spanner
20
Hoist (for Indoor Unit)
6
Copper Pipe Bender
13
Weigher
21
Ammeter
7
Manual Water Pump
(for Indoor Unit)
14
Charging Cylinder
22
Voltage Meter
15
Gauge Manifold
23
Wrench
