Hitachi RAC-SX10HYK, Instruction Manual, Page: 15 / 52

– 15 –
ENGLISH
DEUTSCH
FRANÇAIS
IT
ALIANO
SP
ANISH
POR
TUGUÊS
∂ÏÏËÓÈο
Р
У
ССКИЙ
HEATING OPERATION
DEHUMIDIFYING OPERATION
( ( M I S T / A I R
PURIFYING) indicators also
turn on during quick laundry
operation.)
Press the (HEAT) button to start heating operation.
3 types of dehumidifying operations can be performed by pressing the (DEHUMIDIFY) button.
Performs powerful dry operation without lower down the room temperature.
Condensation
Control
•
In auto dehumidifying mode, fine adjustment of room temperature (page 13),
humidity adjustment and fan speed selection (page 14) can be made to your
preference.
Every time you press the ROOM TEMPERATURE button, the temperature
will change by 1°C. (Temperature setting range is not higher or lower than 3°C.) Every
time you press the HUMIDITY button, the humidity will change by 5%. (Humidity setting
range is 40%~70%.)
•
In quick laundry mode, fine adjustment of room temperature (page 13) and fan
speed selection (page 14) can be made to your preference. (Fine adjustment of
room temperature and humidity adjustment cannot be made in condensation
control mode.)
Press the (HEAT) button.
•
Adjust the room temperature and fan speed to your preference.
Temperature range between 16°C~32°C can be set. (Page 14)
Press the (START/STOP) button.
•
A short beep sounds and heating operation stops.
Press the (DEHUMIDIFY) button.
•
Every time you press the (DEHUMIDIFY) button, the
mode will change as shown in the chart below.
Press the (START/STOP) button.
•
A short beep sounds and dehumidifying operation stops.
•
After the dehumidifying operation is stopped, the remote controller will display
the operation mode that had been set before the (DEHUMIDIFY) button was
pressed.
(“AUTO” flashes for 5 seconds)
Auto
Dehumidifying
Quick
Laundry
STOP
STOP