– 20 –
1. PRE-FILTER
Clean the pre- lter, as it removes dust inside the room. In case the pre- lter is full of dust, the air ow will
decrease and the cooling capacity will be reduced. Further, noise may occur. Be sure to clean the pre- lter
following the procedure below.
Open the front panel and remove the pre- lter
●
Gently lift and remove the air purifying lter
from the pre- lter frame.
Vacuum dust from the pre- lter and air purifying
lter using vacuum cleaner. If there is too much
dust, pre- lter only rinse under running tap water
and gently brush it with soft bristle brush. Allow
pre- lters to dry in shade.
●
Re-insert the air purifying lter to the lter
frame. Set the lter with “FRONT” mark facing
front, and slot them into the original state.
●
After attaching the pre- lters, push the front
panel at three arrow portions as shown in
gure and close it.
CAUTION
●
Do not wash with hot water at more than 40°C. The lter may shrink.
●
When washing it, shake off moisture completely and dry it in the shade; do not expose it directly to the sun.
The lter may shrink.
●
Do not use detergent on the air purifying lter as some detergent may deteriorate the lter electrostatic
performance.
!
1
2
3
MAINTENANCE
Cleaning and maintenance must be carried out only by quali ed service personnel.
Before cleaning, stop operation and switch off the power supply.
CAUTION
!
NOTE:
●
Air purifying lter should be cleaned every month or sooner if noticeable loading occurs. When
used overtime, it may lose its deodorizing function. For maximum performance, it is recommended
to replace it every 1 year depending on application requirements.
