Hitachi RAC-18WPD, Service Manual

Page: 9 / 93

– 1 –
Remote
Controller
Manual
Remote
Controller
manual
Page 1~28
To obtain the best performance and ensure years of trouble free use, please read this instruction manual completely.
MODEL
RAR-6N1
– 2 –
PREPARATION
BEFORE
OPERATION
■
To
install
the
batteries
■
To
x
the
remote
controller
holder
to
the
wall
1.
Slide the cover to take it off.
2.
Install two dry batteries AAA.LR03 (alkaline). The direction of the batteries should match the marks in the case.
3.
Replace the cover at its original position.
1.
Choose a place from where the signals can reach the unit.
2.
Fix the remote controller holder to a wall, a pillar or similar location with the provided screws.
3.
Place the remote controller in the remote controller holder.
NOTE
Notes
on
batteries
●
When replacing the batteries, use batteries of the same type, and replace both old batteries together.
●
When the system is not used for a long time, take the batteries out.
●
The batteries will last for approximately 1 year. However, if the remote controller display begins to fade and degradation of reception performance occurs within a year, replace both batteries with new size AAA.LR03 (alkaline).
●
The attached batteries are provided for the initial use of the system. The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
Notes
on
the
remote
controller
●
Never expose the remote controller to direct sunlight.
●
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
●
Signal communication may be disabled if an electronic- starter-type fl
uorescent lamp (such as inverter-type lamps)
is in the room. Consult the shop if that is the case.
●
If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.
●
When the remote controller is not in use, please close the
slide cover to prevent failure.
Remote
controller
Screws
Remote
controller
holder
9