– 33 –
H
SI
L
G
N
E
INFORMATION
Heating Capability
s
This room air conditioner utilizes a heat pump system that absorbs
exterior heat and brings it into a room to be heated. As the ambient
temperature gets lower, heating capability will also lower. In such a
situation, the inverter work to increase compressor rpm to keep the
unit’s heating capability from decreasing. If the unit’s heating
performance is still unsatisfactory, other heating appliances should
be used to augment this unit’s performance.
s
The air conditioner is designed to heat an entire room so that it may take some time before you feel warm. Timer
operation is recommended for effective preheating ahead of the desired time.
Cooling and Dehumidifying Capabilities
s
If the heat present in a room exceeds the unit’s cooling capacity (for example, if there are many people in the
room or other heating appliances are used), the preset room temperature may not be reached.
PROHIBITION
CAPABILITIES
Do not use a stove or
any other high tempera-
ture devices in proximity
to the indoor unit.
s
When fan speed, room temperature are set with the remote controller before starting manual operation and the
buttons are released, the indication of settings will go off in 10 seconds and only the operation mode will be
displayed.
s
Pressing the
button while the unit is in operation will let the protective circuit work so that the unit will not
operate for approximately 3 minutes.
s
During heating operation, the “OPERATION” lamp on the indoor unit indicators may blink with no air emitted for
a while.
s
If you feel cold wind during heating operation with the
(HI) fan speed or want to make the unit operation
quieter after the room is heated, use of
(AUTO) setting is recommended.
s
With the
(LOW),
(SILENT) settings, the unit’s cooling capacity will lower slightly.
s
With the
(LOW),
(SILENT) settings, the unit’s fan speed of heating operation will vary with the operating
conditions.
VARIOUS FUNCTIONS
s
When the timer has been programmed, the unit will not operate even if the set time is reached unless the unit
receives a signal from the remote controller. Confirm that timer programming is complete (beep) and the TIMER
lamp of the indoor unit lights.
s
If the
(SLEEP) button is pressed while the ON/OFF timer is programmed, the sleep timer takes priority.
s
During sleep timer operation, the fan speed sets to
(SILENT) regardless of the preset speed. The remote
controller display indication will remain unchanged even with the
(SILENT) setting.
TIMER PROGRAMMING/SLEEP TIMER OPERATION
CAUTION
Summary of Contents for RAC-10JH5
Page 2: ... 2 ...
Page 40: ... 40 ...
