Hitachi RAC-10JH4, Instruction Manual

Page: 9 / 36

– 9 –
ENGLISH
DEUTSCH
FRAN
Ç
AIS
IT
ALIANO
SP
ANISH
POR
TUGU
Ê
S
∂ÏÏËÓÈο
Р
УССКИЙ
●
SELF CLEAN Button
Use this button to set the self clean mode.
●
AUTOMATIC TWO WAY AIR EXCHANGE Button
Press this button to set the automatic two way air exchange mode.
●
AIR PURIFIER Button
Press this button to start the air purifier mode.
●
FAN SPEED Selector
This determines the fan speed. Every time you press this button, the
intensity of circulation will change from “
(AUTO)
➔
(HI)
➔
(MED)
➔
(LOW)
➔
(SILENT)” cyclically.
●
FUNCTION Selector
Use this button to select the operating mode. Every time you press this
button, the mode will change from “ (AUTO)
➔
(HEAT)
➔
(DEHUMIDIFY)
➔
(COOL)
➔
(FAN)” cyclically.
●
AUTO SWING Button
Controls the angle of the horizontal air deflector.
●
FRESH AIR IN DURING SLEEP MODE Button
Use this button to set the fresh air in during sleep mode.
●
RESERVE Button …Time setting reservation.
●
CANCEL Button …Cancel time reservation.
●
TIMER Control …Use these buttons to set the timer.
●
TIME Button …Use this button to set and check the time.
●
OFF-TIMER Button …Select the turn OFF time.
●
ON-TIMER Button …Select the turn ON time.
●
RESET Button
Press this button after the batteries are replaced or when some irregular
operation is found.
AUTO
HEAT
DEHUMIDIFY
COOL
FAN
FAN SPEED
TWO WAY AIR EXCHANGE
TWO WAY AIR EXCHANGE FAN SPEED
EXHAUST
FRESH AIR IN
FRESH AIR IN DURING SLEEP MODE
SILENT
LOW
MED
HI
HI
MED
LOW
SLEEPING
STOP (CANCEL)
START (RESERVE)
START/STOP
TIME
TIMER SET
TIMER SELECTOR
ON TIMER
OFF TIMER
AUTO SWING
SELF CLEAN
AUTOMATIC TWO WAY AIR EXCHANGE
AIR PURIFIER
Precautions for Use
• Do not put the remote controller in the following places.
• In direct sunlight.
• In the vicinity of a heater.
• Handle the remote controller carefully. Do not drop it on the floor, and protect it from water.
• Once the outdoor unit stops, it will not restart for about 3 minutes (unless you turn the power switch off and
on or unplug the power cord and plug it in again). This is to protect the device and does not indicate a failure.
• If you press the FUNCTION selector button during operation, the device may stop for about 3 minutes for
protection.