9
/
20
2. Installation of the Biometric Reader
2.1 Place the Biometric Reader
Install the Biometric Reader on a horizontal and stable surface. Ensure no light through a
window or from lamps can enter the scanning area of the Biometric Reader.
It is recommended that you use the Biometric Reader in the 300-1000 lx luminance range,
which is equivalent to the brightness suitable for reading a newspaper.
Important
Do not use the Biometric Reader in places where the Biometric Reader is exposed
to strong light such as outdoors, near windows or near a light source, which may
lead to an authentication failure.
2.2 Power On
Slide power switch (left side of the unit) to power on.
USB mode
Power OFF
Bluetooth mode
With USB cable connection
(powered by USB)
- Power On
- Connected by USB
- Power Off
- Power On
- Connected by Bluetooth
Without USB cable connection
(powered by internal battery)
- Power Off
- Power Off
- Power On
- Connected by Bluetooth
Important
Biometric Reader can’t power up in USB mode without USB bus power.
Biometric Reader may generate a little heat due to the use of infra-red light inside,
but this will not cause malfunctions.
Do not connect more than one Biometric Readers simultaneously to one PC. If
more Biometric Readers are connected, they will not work properly.
After connecting the Biometric Reader to your PC, wait for at least 5 seconds
before performing any operation.
USB mode
Bluetooth mode
Power Switch
Power OFF
