5.1.3
Setting method
N O T E
To adjust the air flow angle, refer to the installation and operation
manual of indoor unit.
Temperature setting
Point the transmitter towards the receiver kit and press “TEMP.”
switch to set the temperature.
By pressing “ ”, the temperature is increased by 1ºC.
By pressing “ ”, the temperature is decreased by 1ºC.
COOL
°C
Me
The set temperature is set to 28ºC
in the cooling operation
N O T E
•
The temperature is not displayed during the stoppage. In the
case that the temperature is set during the stoppage, the tem-
perature indication is turned ON temporally. It is automatically
turned OFF after setting.
• The temperature can be set for each operation mode.
•
The setting temperature is available from 17ºC to 30ºC by
the wireless remote control switch. However, for indoor unit
which setting temperature range is 19~30ºC, the temperature
settings of 17ºC and 18ºC are not available.
Fan Speed
Point the transmitter towards the receiver kit and press “FAN”
switch to set the fan speed.
COOL
°C
Hi
The fan speed is set to “Hi”
in the cooling operation.
By repeatedly pressing the switch, the setting will change se
-
quentially through Hi2, Hi, Me and Lo.
Hi2
Hi
Me
Lo
N O T E
•
The fan speed is not displayed during the stoppage. In the
case that the fan speed is set during the stoppage, the fan
speed indication is turned ON temporally. It is automatically
turned OFF after setting.
•
The fan speed can be set for each operation mode. However,
the fan speed will be fixed at “Lo” in dry operation.
Air flow direction
Point the transmitter towards the receiver kit and press
“LOUVER” switch to set the louver angle.
COOL
°C
Hi
The louver angle is set
to 1 step at “Hi” in the
cooling operation.
By pressing “LOUVER” switch, the louver angle will be changed
as follows.
-
1
2
3
4
5
6
7
Step LCD indication COOL, DRY HEAT, FAN
Auto-swing
Recommen
-
ded angle
Recommen
-
ded angle
Angle
range
Angle
range
: Auto swing operation will be started. At this time, the louver
will swing repeatedly on LCD.
N O T E
•
The louver angle is not displayed during the stoppage.
•
The louver setting are only available from 1 step through 5
step and auto swing at the cooling and dry operation modes.
•
The louver angle may be changed automatically during the
heating operation. (Refer to the installation and operation ma-
nual of indoor unit about detail.)
•
The louver may NOT stop immediately right after the switch
is pressed.
•
The auto louver mechanism is not available for In-the-Ceiling type
.
6
PMML0264A rev.1 - 09/2015 - P5416575
Operation
