Hitachi P42T501, P42T501A, P50T501, P5, Operating Manual

Page: 33 / 159

FUNCTION FOR YOUR CABLE BOX.
This remote is designed to operate different types of
cable boxes. You must first program the remote to
match the remote system of your cable box (refer to
pages 37-38 for pre-codes).
1. Turn ON your cable box.
2 . To switch to Cable (CBL) pre-coded mode, use the
SOURCE SELECT
button on the remote control
to position the LED light to the corresponding
selection
SAT/CBL
.
3. Hold down the
SOURCE SELECT
button on the
remote and enter the four digit preset code that
matches your cable box as shown on pages 37-38.
Release the
SOURCE SELECT
button. The indicator
light will flash 3 times if the code was accepted.
4. Aim the remote at the cable box and press the
POWER
button. The remote will turn off your cable
box when the correct four digit preset code is
entered. When this occurs, the remote control is
programmed for your cable box. If the cable box
does not turn off, try a different four digit preset
code.
5. The remote will now control your Cable box.
NOTE: 1. If your cable box cannot be operated after
performing the above procedures, your
cable box code has not been precoded
into the remote.
2. In the unlikely event that your cable box
cannot be operated after performing the
above procedures, please consult your
cable box operating guide.
3. The remote control will remember the
codes you have programmed until the
batteries are removed from the
remote control. After replacing the
batteries repeat the entire programming
procedure as stated above.
햲
PRECODED CABLE BOX buttons
These buttons transmit the chosen precoded cable
codes.
햳
EXCLUSIVE TV buttons
These buttons are for operating the TV.
MY CABLE BOX CODE IS:
NOTE: Refer to instruction manual of the Cable Box
for operation of the buttons exclusively for
the Cable Box.
The Remote Control for Cable Box Functions
햲
햳
햲
햳
햲
햳
햳
햳 햲
햲
OPERATING THE PRECODED
32
T
h
e
R
e
m
o
te
C
o
n
tr
o
l