--- 37 ---
10-5. Disassembly and Reassembly of the Cap and the Magazine
(1) Cap portion
Tool required:
Hex. bar wrench (4 mm)
(a) Disassembly (See Fig. 24.)
Remove the Hex. Socket Hd. Bolt M5 x 16 [44]. Then Gasket (D) [42] and the Cap [43] can be removed.
(b) Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse.
Before reassembly, check that no dust is adhered to the end surfaces of the Body Ass'y [24] and the Cap [43],
and Gasket (D) [42].
(2) Magazine portion
Tool required:
Hex. bar wrench (4 mm)
Philips screwdriver
Roll pin puller (4 mm (0.157"))
Small flat-blade screwdriver
(a) Disassembly (See Fig. 23.)
Remove the Machine Screw M5 x 22 [39] from the Body Ass'y [24]. Then the Magazine Ass'y [109] can be
removed.
Push out the Pin [101] using a roll pin puller (4 mm (0.157")). Then the Magazine Cover [90] and the
Feeder Shaft Ring [72] that prevents the Pin [101] from coming off can be removed.
Insert a small flat-blade screwdriver between the Holder Cap [91] and the Nail Holder [99] to widen the
clearance. Then the Holder Cap [91] can be removed (Fig. 23). At this time, be careful not to scratch the
Nail Holder [99] and the Holder Cap [91]. Remove the Machine Screw M4 x 50. Then the Holder Shaft
[95], Nail Holder [99] and other parts can be removed.
Put the small flat-blade screwdriver on the end of the Ratchet Spring [98] and push the Ratchet Spring [98]
out of the groove on the Nail Holder [99].
(b) Reassembly
Disassembly procedures should be followed in the reverse order.
Drop the Feeder Shaft Ring [72] in the groove at the center of the hinge of the Magazine Cover [90] and
put the Pin [101] through the hole of the hinge before mounting the Magazine Cover [90] to the Magazine
[100]. After reassembly, check that the Feeder Shaft Ring [72] fits in the notch at the center of the Pin
[101].
Fig. 23
Holder Cap [91]
Nail Holder [99]
Small flat-blade
screwdriver
