9-6
●
On-screen message descriptions
No.
Message
Meaning of message
Remedy
49 Print Overlap Fault
The print target detecter signal for the next
target arrived during the print operation for
the current target.
●
Increase the spacing between
products.
●
If the target signal is
chattering, use sensor filter
setting. ( 4.14.1).
50
Print Head Cover
Open
The print head cover is open.
●
Remove the cover and then
hit the Clear key.
●
If a magnetic substance is
used to fix the cover,
it must be replaced with
nonmagnetic resin (metal).
51
Detector Position
Improper
The print target detecter signal turned OFF
before print start during printing at repeat
print setting.
●
Move the print target detecter
closer to the print head.
●
If the target signal is
chattering, use sensor filter
setting.
●
Check the data entered.
52
Target Sensor Time
Out
The print target detecter signal was ON
longer than the timeout setting of Target
Sensor Timer.
●
If the target is stopped in front
of the sensor, move the target.
●
Change the Target Sensor
Timer setting.
( 4.14.1).
53
Target Spacing Too
Close
There are 5 or more print target detector
signal turned ON before print start during
printing at No repeat print setting.
●
Move the print target detecter
closer to the print head.
54
Print Data
Changeover In
Progress S
A print operation was requested while the
print data was being changed.
●
If the target signal is
chattering, Use Sensor filter
setting.
●
Change of timing either print
data change or print start.
55
Ink Self Life
information
Replacement of ink is recommended.
●
Use ink within its expiration
dae at replacement.
●
Confirm ink of number on
unit information screen.
●
Contact your nearest local
distributor.
56 Blank Print Items
The print items are not properly set up.
●
Change the print data.
57
Excessive Format
Count
A column has more than 8 print format
types (the number of lines, line spacing,
character size, character spacing, bold
charcter and bar code).
●
Perform setup so that the
number of print format types
does not exceed 8.
58
Print Data
Changeover In
Progress M
A print operation was requested while the
print data was being changed.
●
Change timing of either print
data change or print start.
59
Print Data
Changeover In
Progress V
A print operation was requested while the
video data was being changed.
●
Adjust either the encoder
frequency or the pulse rate
division factor.
●
Change timing of either print
data change or print start.
60
Communication
Buffer Fault
The print contents are not in the
communication buffer.
.
●
Adjust the print and
communication timing.