6
Prepar
ation
Installing the LCD
TV
Using The
F
eatures
T
roub
leshooting
Specifications
Using
The DTV F
eatures
Introducing the LCD
TV
Your LCD TV
How to setup the TV
Do not use caustic cleaners ( porcelain, stainless steel, toilet, or oven cleaner etc. ) on the remote,
as it may suffer damage.
Use an antenna cable to connect the VHF / UHF signal to the LCD TV’s ANT. terminal
( refer to page 13 ).
Connect the AC power cord at the back of the TV and connect the power cord to wall outlet.
Insert the 2 batteries supplied in remote control.
Connect other an external A/V device
( refer to page 14-17 ).
Step1 Press and lift the back cover up to open the battery
compartment of the remote control.
Step2 Insert two AAA size batteries. Make sure to match the ( + )
and ( - ) ends of the batteries with the ( + ) and ( - )
ends indicated in the battery compartment.
Snap the cover back into place.
1
2
3
4
Effective range
Your remote control can be activated from up to the LCD TV 5m away, if points directly in
front of the device.
5M
30
O
30
O
Handling the Remote Control
ƒ
It could cause corrosion or battery leak age and may result in physical injury and/or property
damage including fire.
ƒ
Never mix used and new batteries in the device.
ƒ
Replace all the batteries in a device at the same time.
ƒ
Remove the batteries if the remote control is not going to be used for an extended period of time.
ƒ
To avoid possible failure, read the following instructions and handle the remote control property.
ƒ
Do not drop or cause impact to the remote control.
ƒ
Do not spill water or any liquid on the remote control.
ƒ
Do not place the remote control on a wet object.
ƒ
Do not place the remote control under the direct sunlight or near sources of excessive heat.
NOTE:
Remove the battery from remote control handset when it is not to be used for a long period.
Otherwise it can be damaged due to leakage of battery.
