- 22 -
• Highlight
Yes
or
No
by using “ ” or “ ” buttons and
press
OK
button to confirm.
• If
Yes
is selected, automatic search starts.
• Selecting
No
cancels automatic search.
• After the scanning is completed, your set top box will
store all the available channels.
Manual Channel Scan
• This feature can be used for direct broadcast
entry.
• Select Manual Channel Scan by using “
” or “ ”
button and press OK button.
• In manual channel scan, the number of the multiplex
is entered manually and only that multiplex is
searched for the channels.
• For each valid channel number, signal level and
signal quality are shown on the screen.
• In both manual and auto search, any existing channel
in the database is not re-stored to avoid duplicates
of that channel.
Format Disk
If you want to format the internal hard disk, you can
use
Format Disk
option.
ALL the data stored on the
hard disk will be lost in such a case
.
• Press
OK
when the
Format Disk
option is
highlighted. A menu appears, requiring you to enter
the pin number. If you have not changed the pin
number, the factory default is 0000.
• After you enter the correct PIN code, a pop-up menu
appears on the screen to ensure that the hard disk
should be formatted.
• Select
YES
and press
OK
to format the hard disk.
Select
NO
and press
OK
to cancel.
First Time Installation
• If you want to load default settings of your set top
box, you can perform first time installation.
• Select
First Time Installation
by using “ ” or “ ”
button and press
OK
button.
• The following message will be displayed;
• Highlight
No
by using “ ” or “ ” button to cancel
installation.
• Highlight
Yes
by using “ ” or “ ” button and press
OK
button
to start first time installation.
• After you select
Yes
, factory settings will be loaded.
• Installation wizard will guide you through the
installation process. See the section, “
First
Time Installation
” in previous chapters for more
information on this process.
IP Settings
• You can configure your receiver’s IP settings by using
this menu screen.
• Press
YELLOW
button to set static IP settings.
• Use
BLUE
button to configure dynamic IP settings.
• You can press
RED
button to disable IP configuration.
• In order for the ethernet host to work correctly with
your internet connection it needs to have a unique
IP address. In most cases all of the parameters can
be provided by the DHCP server in their router. In
this case you should use the “
Dynamic
” option.
• In the unlikely event that you dou not have a DHCP
server in your router or if you prefer to assign your
own IP address, then the “
Static
” option can be
used. You will need to enter a unique IP address
along with the default gateway and DNS server. In
most domestic networks the default gateway and
DNS server will both be the IP address of the router.
Available MAC address will be displayed on MAC
address line.