- 9 -
Power On-Off
Connect all cables before plugging into the mains. After plugging in the AC adaptor for the set top box
to the mains supply, red light will be seen on the front panel (Standby mode). When the set top box
is first powered up please wait until the box is initialized before activating the receiver since booting
of software will take some time. Please wait until unit is initialized. This may take almost a minute.
This product conforms with the latest European Union Power Consumption Regulations and features
a low power standby mode. The product enters into the low power standby mode approximately 30
seconds later after the standby button is pressed to turn off the unit. Until low power mode is activated,
a clock will be displayed at the display and light will be OFF. When the low power mode is activated,
the display will be shut down and light will be red. When you press the standby button during low
power mode, it may take a minute until the product is initialised. However, if you press the standby
button before the low power mode is activated, the unit will be initialized in a couple of seconds
(Active standby mode).Although it is not recommended for enviromental reasons, you may disable
low power mode in your product at setup –configuration menu. If low power mode is disabled, only
clock is displayed in standby mode. When the box is on mode, a channel number will be displayed
at the display and light will be OFF.
Auto Power Down:
This box will automatically switched from active mode into standby mode, after less than three hours
in active mode, following the last user interaction and/or a channel change with an alert message
two minutes before going in to standby mode. The Automatic power-down can be set as disabled, 2
hours, 3hours, 4hours, 6hours or 8hours from the configuration menu.
Important Note :
If there is any ongoing programme recording or if any EPG programme recordings
and/or manual recordings are set to a nearby time, the unit does not switch to low power mode and
remains in active standby mode until recording tasks have been finished. In low power mode, the unit
initializes a couple of minutes before the actual time of the incoming recording task.
Important Note :
The unit initializes from time to time to receive updates from the EPG broadcast
in order to synchronize EPG recording tasks properly. After getting updates, the unit switches to low
power mode automatically. This takes a short while and it is not a malfunction.
