Hitachi DZ-B35A, Instruction Manual, Page: 41 / 167

41
English
Basic Techniques
This section explains about recording of movies and still images, and also basic settings on
DVD video camera/recorder.
1<>2/
Recording Movie
1
Remove the lens cap, and then point the DVD
video camera/recorder at subject.
2
Turn the DVD camera/recorder on.
Set the power switch to “
O
” to turn the DVD
video camera/recorder on.
After the ACCESS/PC indicator goes out,
perform the subsequent operation:
3
Check the subject on the screen (viewfinder
or LCD).
When using the viewfinder, close the LCD
monitor before pulling out the viewfinder.
4
Press the REC button.
The “
m
” mark in the viewfinder or on the
LCD screen will change to the “
n
” mark,
and recording will start.
During recording, the recording indicator on
the front of DVD video camera/recorder will
light.
Pressing REC again during recording will set
the DVD video camera/recorder to the
recording pause status.
5
When recording is finished, turn the DVD
video camera/recorder off.
Note
:
• See “Troubleshooting” on page 139 when recording
movie is not possible.
• See “Troubleshooting” on page 139 if it takes some
time before recording is possible.
• See “Troubleshooting” on page 139 if the DVD video
camera/recorder does not operate.
• See page 44 for on-screen information display.
• While the ACCESS/PC indicator is lit or blinking, do
not turn the DVD video camera/recorder off, and take
care not to subject it to any vibration: Doing so could
cause an error in the recorded data, which could
make it unplayable (see page 7).
• The minimum recordable time of movie is
approximately 3 seconds.
• See page 35 for setting of Record LED (recording
indicator) On/Off.
• For various functions available during recording, see
“Setting Up Camera Functions” on page 57.
• Hitachi cannot be responsible for video and audio that
cannot be recorded or edited because of any defect.
• The power switch can be changed over even during
recording, but the operation will not be changed.
• It is recommended that you set the LOCK switch to
L
(the upper position) to prevent the power switch in the
“
O
” position from accidentally moving to “
N
” position.
• Each time the DVD video camera/recorder enters the
recording pause status, the counter display will be
reset to “0:00:00”.
• If, when using a +RW, one-time recording duration is
short or you frequently switch the video quality,
recording may not be possible even when the disc
has remaining space.
Before You Begin
• Insert a recordable DVD-RAM/DVD-RW/DVD-R/+RW disc into this DVD
video camera/recorder.
OFF
ACCESS/PC
indicator
Pressing REC
once will start
recording;
pressing it once
again will
temporarily stop
recording.